I used smi_mptool_v2.03.34_v7_j1118_3254ae and now it works.Īfter few minutes the device is ready to use.ĮDIT 6 – for Autodesk Product Design Suite Ultimate 2013 Inside my USB Drive (also named DaneElec zMate USB 32 GB) I found a controller SM3254Q AE, produced by SMI. Format the drive using the Windows format tool (or other tool of your choice) as NTFS.ĮDIT – 5 From the comments, for DaneElec zMate USB 32 GB: Unplug your USB drive and plug it back in.ĥ.
#Usb burning tool 2018 download#
Download the file from this link… and extract it to your drive.ģ.
I found a solution for the latest drive that I received with the PS2251-67 Controller.ġ. Set Controller to PS2251-62 and FC1-FC2 to 01ĮDIT 7 – For PS2251-67 (From Ryan Ruta in the Comments) Run getinfo in MPALL_F1_9000_v363_0C folder
#Usb burning tool 2018 code#
In Firmware tick ‘Do ISP’ ‘Erase Code Block’ and ‘Auto ISP’ Set Controller to PS2251-67 and FC1-FC2 to 01 Recieved Brand New USB’s For Autodesk Design Suite 2013 Premiumĭownload MPALL_F1_9000_v363_00 and MPALL_F1_9000_v363_0C You can try this process in MPALL (step 1 above): Run MPALL 363 c (as per settings below) (make sure its revision C).This may seem a bit long winded, but I think it might be a good way for 2013 media kit:
YOU MUST USE USB3Ĭopy the contents between the = to a new file named 2014_2251-03.iniĬlick Setting, select “Advanced Setting” then press OKĬlick the load button and select the 2014_2251-03.ini file you created earlier. He also provides a link to download the proper version, at: Do not try to force a certain BIN file onto the drives firmware using MPALL.Do not use the formatter.zip on the latest 2014 version TOSHIBA USB 3.0 with the 2251-03.Click start, the process lasts for about a minute and it’s doneWARNINGSThere is some evidence of newer drives being bricked.Close settings window by clicking on “x”.Choose advance settings and load the ini file, the same that Mike created.Start it, put your usb stick into your USB 3.0 port.